Using the home theater mode – One for All (URC-8910) User Manual

Page 31

USING THE HOME THEATER MODE

Control Organization

About Device Groups (continued)

The default Device Group settings from the factory is:

(1) Playback Group:

VCR

(2) Audio Group:

(3) Channel Group:

CBL

(4) Menu Group:

CBL

(5) PIP Group:

Programming The Home Theater Mode

For example, let’s assume you have a TV, a cable converter, and a VCR
in your home theater system.You can set up the Home Theater mode
so that selected controls are assigned to these devices as follows:

On the URC-8910 remote control, press and hold
SET until you see the display change from the cur-
rent device and time to [CODE SET].

NOTE: The device, its code, and time are examples. Your
remote control settings may be different.

NOTE: To exit programming at any time, press EXIT once or
allow 30 seconds of inactivity to lapse. You will see [EXIT
SETUP] as the remote control returns to normal operation.

NOTE: [INVALID] means you have inadvertently pressed an
incorrect key. Note your error and continue programming.

(x 3)

Press the

▲

key three times until you see the display

change to [THEATER].

NOTE: If you go past [THEATER], press the

▼

key one or

more times to return to it.

Press SELECT once to begin programming.You will
see the display change to [PLAYBACK].

NOTE: The program will automatically step through each
Control Group (from Playback to PIP) as you perform steps
3 through 7. However, you can use the

▲

▼

keys to navi-

gate to a specific group to make further changes.

Producer 2002 IR Mnl 4/4/02 10:02 AM Page 44