Oregon Scientific SE833 - Manual (Page 8)

E
N
8
UPLOAD CUSTOM EXERCISE PROFILE FROM PC
APPLICATION SOFTWARE
You can upload up to 3 exercise profiles from the PC
application software to your watch with customised setting.
But you cannot modify the settings of the uploaded exercise
profiles through the watch, you can only modify them
through the software.
For more details about uploading custom exercise profiles
from software to the watch, refer to “SYNCHRONISING
SE833 WATCH WITH PC APPLICATION SOFTWARE” in
this manual.
For more details about modifying the custom exercise
profiles in the software, refer to “CREATE OR MODIFY
USER PROFILE / DEVICE SETTING” in the PC Application
Software User Guide inside the CD-ROM.
NOTE If no custom exercise profile is uploaded from the
software to the watch, the watch will only display its default
exercise profiles.
WEARING CHEST BELT
1. Wet the conductive pads on the underside of the chest
belt with a few drops of water or a conductive gel to
ensure solid contact.
conductive pads
2. Strap the chest belt across your chest. To ensure an
accurate heart rate signal, adjust the strap until the belt
sits snugly below your pectoral muscles.
TIPS
• The position of the chest belt affects its performance.
Move the chest belt along the strap so that it falls above
your heart.
• Avoid areas with dense chest hair.
• In dry, cold climates, it may take several minutes for the
chest belt to function steadily. This is normal and should
improve with several minutes of exercise.
• To maintain the best performance of your chest belt,
please handle it with care according to the following:
- Do not wrap the chest belt in a wet towel nor with
other wet materials.
- Do not store the chest belt in a hot (about 50°C)
SE833 EN 11.indd 8 6/1/09 10:07:13 AM