Runco LIGHTSTYLE LS-10I - Manual (Page 95)

External Control
Runco LS-10i Installation/Operation Manual 79
PRE
L
IMINAR
Y
Operations Commands: Operations commands allow more flexible and direct control of
the projector. The syntax for operations commands is as follows:
op [CR]
(Precede and with a space.)
The command type can be one of 5 functions:
Table 6-2 lists the valid operations commands. For all but Execute functions, the response
from the projector is the command and “= ” where is the current value or
“NA” if the value is not available. For Execute functions the response is the same
command. All responses are in UPPERCASE.
Some operations command examples:
Input: op bright ? [CR]
Response: OP BRIGHT = 100 [CR]
Input: op bright + [CR]
Response: OP BRIGHT = 101 [CR]
Input: op bright = 127 [CR]
Response: OP BRIGHT = 127 [CR]
Input: op bright - [CR]
Response: OP BRIGHT = 126 [CR]
Input: op resync [CR]
Response: OP RESYNC [CR]
Input: op sharp.mode = 1 [CR]
Response: OP SHARP.MODE = 1 [CR]
Input: op sharp.simple = 50 [CR]
Response: OP SHARP.SIMPLE = NA [CR]
Input: op sharp.simple ? [CR]
Response: OP SHARP.SIMPLE = NA [CR]
Operations Control Commands
Function Command Action on unit
Set
=
Makes the unit take that value.
Get
?
Asks what the current value is.
Increment
+
Adds 1 to the current value.
Decrement
-
Subtracts 1 from the current value.
Execute
(none)
Performs an action such as a reset.