6 connections to the ls-10i, Connector panel access, Connections to the ls-10i – Runco LIGHTSTYLE LS-10I User Manual

Page 45: Pre l iminar y

Runco LS-10i Installation/Operation Manual

PRE

IMINAR

3.6
Connections to the
LS-10i

Proceed as follows to connect the LS-10i to your video sources, external controller(s) – if
present – and AC power.

When connecting your equipment:

• Use the correct signal cables for each source.

• Ensure that the cables are securely connected. Tighten the thumbscrews on

connectors that have them.

Connector Panel Access

Using a flat-blade screwdriver, loosen the two
screws holding the rear compartment cover
in place.

Then, remove the rear compartment cover by
tilting it upward.