Runco LIGHTSTYLE LS-10I - Manual (Page 92)

External Control
76 Runco LS-10i Installation/Operation Manual
PRE
L
IMINAR
Y
Key Commands: The syntax for key commands is simple:
ky [CR]
Some key command examples:
ky menu[CR] Bring up or cancel menu display.
ky mem.sw[CR] Switch to next user memory.
ky asp.16.9[CR] Apply 16:9 aspect ratio.
The response from the projector for key commands will be the same command in
UPPERCASE.
Input: ky mem.sw[CR]
Response: KY MEM.SW [CR]
Table 6-1 lists the serial command key names and IR codes. Use the IR codes to program
a third-party remote control unit.
Table 6-1. Serial Command Key Names and IR Codes
IR Code
RS232
Keyname
Remote Button Description
0x00 pow.on Turn power on. If the projector is already on, this
toggles the input panel backlight.
0x45 pow.off Turn power off.
0x02 src.video Switch the active source to Video.
0x1f src.svid Switch the active source to S-Video.
0x0a src.hdmi1 Switch the active source to HDMI 1.
0x50 src.hdmi2 Switch the active source to HDMI 2.
0x1e src.1 Perform action assigned by user to HD 1 button
(switch active source or change PIP state).
0x40 src.2 Perform action assigned by user to HD 2 button
(switch active source or change PIP state).
0x58 src.3 Perform action assigned by user to HD 3 button
(switch active source or change PIP state).
0x1b info Bring up an information box with the first seven (7)
items in the Service menu.
0x19 menu Bring up or cancel menu display.
0x5c exit Exit all menus.
0x51 enter Keypad enter. If PIP is active and no menu is
present then this executes the PIP swap function.
ON
OFF
VID
S-VID
HDMI 1
HDMI 2
HD 1
HD 2
HD 3
INFO
MENU
EXIT
ENTER