Ricoh AFICIO CL3000DN User Manual
Page 33
802.11b Interface Unit Type A
29
1
GGGG
Press
{{{{U
U
U
U}}}} or {{{{T
T
T
T}}}} to select the
transmission mode.
Note
❒ The factory default is “802.11
Ad hoc”.
❒ To use an IEEE 802.11b card for
w h i c h t h e S S I D ( N e t w o r k
Name) setting is not necessary,
select "Ad hoc".
HHHH
Press
{{{{Enter #}}}}.
The display returns to the previous
menu in a few seconds.
IIII
If "802.11 Ad hoc" or "Ad hoc" is
selected for "Comm. Mode", set
the channel to use for transmis-
sion.
Note
❒ Confirm the network adminis-
trator for the channel to use.
A Press {{{{U
U
U
U}}}} or {{{{T
T
T
T}}}} to display
"Channel".
B Press {{{{Enter #}}}}.
The channel currently used ap-
pears on the panel display.
C Press {{{{U
U
U
U}}}} or {{{{T
T
T
T}}}} to enter the
channel.
D Press {{{{Enter #}}}}.
JJJJ
Set "Trans. Speed" in the same
way.
Note
❒ The factory default is “Auto”. If
you need to change the trans-
mitting speed depending on en-
vironment you are using, select
the appropriate transmitting
speed.
KKKK
Press the
{{{{U
U
U
U}}}} or {{{{T
T
T
T}}}} key to dis-
play "SSID", and then press the
{{{{Enter #}}}} key.
The following message appears on
the panel display.
Note
❒ The factory default is “ASSID”.
❒ If an SSID has been set, you can
check the set SSID. Press the
{{{{U
U
U
U}}}} or {{{{T
T
T
T}}}} key to display
"View", and then press the
{{{{En-
ter #
}}}} key.
A Press the {{{{Enter #}}}} key.
The following message appears
on the panel display.
Note
❒ The value in brackets at the
upper right is the number of
characters entered.
IEEE 802.11b:
Channel
Channel:
(1-11) 11
IEEE 802.11b:
SSID
SSID:
Enter ID
SSID: [ 0]
k
AresPGBOptionSetup-F_FM.book Page 29 Monday, July 29, 2002 1:12 PM