RCA CC6271 - Manual (Page 15)

Power Your Camcorder
13
PUSH
SP/SLP DATE/TIME COUNTER R/M QUICK REC
EJECT
OFF
AUTO
ON LIGHT
FADE TITLE
B A C K L I GHT
FRO NTL IG H T
AUT O
MA N
HAZE 1/1000
SHDW
SEPIA
Use the Battery to Power Your Camcorder
The battery must be charged as described on the next page before it can be used the
first time. Initial charging takes approximately 70 minutes for the FB1260 (100
minutes for the BB700). When fully charged, the FB1260 supplies approximately
50-55 minutes (BB700 approximately 75-85 minutes) of operating time – depending
on how much you use the light, zoom, and pause. Conserve battery power by turning
the camcorder off during recording breaks.
Note: Use the small marker switch on the top of the battery to help remind yourself to charge
the battery. It has no other purpose.
Attach the Charged Battery
If the DC cable is attached to the
camcorder, remove it before attaching
the battery. Also, install the lithium
clock cell before attaching the battery.
Details are on page 17.
1. Hook the top end of the battery to the
back of the camcorder as shown
above.
Battery Safety Precautions
Do not short the battery’s
terminals.
Do not attempt to disassemble or
modify the battery. There are no
user-serviceable parts inside.
Use the battery only with
specified adapter/chargers and
camcorders.
Throwing the battery into a fire
or exposing it to excessive heat –
over 149˚F (65˚C) could be
hazardous.
BATT. RELEASE
Button
2. Press the battery down until it locks
into place.
3. Set the POWER switch to CAMERA.
The power indicator lights.
Remove the Battery
Slide and hold the BATT. RELEASE
button to the right while removing the
battery.
ATTENTION: The RBRC seal on the battery used in your Thomson
Consumer Electronics product indicates that we are participating in a
program to collect and recycle Nickel Cadmium batteries throughout the
United States. Please call 1-800-8-BATTERY for information or
contact your local recycling center. RBRC
RBRC
Ni-Cd
Marker
Switch