Radio Shack 43-3824 User Manual

Page 31

The Integrated Answering Device

announced for your review. After a few seconds,
the system announces “To set security code, press
menu again”.

Setting a Personal Security Code (PIN)

To play your messages from a remote location, you
need to enter a two-digit Personal Identification
Number (PIN) code (01-99). To select a PIN,
perform the following steps:

1. Press

MENU

twice in standby mode.

“Security code” and the current PIN code is
announced as it is displayed on the base.

Then the system announces the guidance for
setting the PIN code.

2. Press

VOL/SEL/

until the

desired number appears.

3. Press

SET/RING

to select the PIN code. You

hear a conﬁrmation tone, then the
announcement “Security code” and the new
PIN code is announced. After a few seconds,
the system announces “To set ring time, press
menu again”.

Setting the ring time

The ring time setting allows you to set the number
of rings the caller hears before your answering
system plays the outgoing message. You can set
the ring time to answer after two, four, or six rings.
Setting

(Toll Saver), the answering system picks

up after two rings if you have new messages, and
after four rings if there are none. This way, if you
make a long distance call to check your messages,
you can hang up after the second ring to avoid
billing charges.

1. Press

MENU

three times in standby mode.

NOTE

The PIN code is set to “80”
when you purchase your
phone.

43-3824.FM Page 31 Friday, February 28, 2003 6:50 PM