Radio Shack 43-3824 - Manual (Page 30)

The Integrated Answering Device
30
The idle time default setting is 10 seconds. If
the base remains idle for 10 seconds, an error
tone sounds and the system returns to standby.
Setting the Time
The clock on the answering system starts when
power is supplied to the base. Follow these steps to
set the clock to the correct time.
Ô
1. Press MENU .
The system announces “Time”, the current time
and the guidance for setting the time. The
message counter displays the current numbers
([ ] through [
]) indicating the day of the week.
2. Press VOL/SEL/
or
VOL/SEL/
until the
correct day is announced. The numbers [ ]
through [
] are displayed on the base.
3. Press SET/RING to select the day.
4. Press VOL/SEL/
or
VOL/SEL/
until you
hear the correct hour setting. The numbers [ ]
through [
] are displayed on the base as each
hour is announced.
5. Press SET/RING to select the hour.
6. Press VOL/SEL/
or
VOL/SEL/
until you
hear the correct minute setting. The numbers
[
] through [ ] are displayed on the base as
each minute is announced.
7. Press SET/RING to select the minute.
8. Press VOL/SEL/
or
VOL/SEL/
until you
hear the correct AM or PM setting.
The message counter displays [ ] or [ ].
9. Press SET/RING to select the AM/PM setting.
You hear a confirmation tone, then the
announcement “Time” and the time and day are
Ô
NOTE
Ô
• Normally the idle time for
the menu mode is 10
seconds before the
system returns to
standby. However for
setting the time, the idle
time is extended to two
minutes.
• Press and hold VOL/SEL/
or VOL/SEL/ to
quickly scroll through the
numbers on the display.
43-3824.FM Page 30 Friday, February 28, 2003 6:50 PM