Regency Zero Clearance Direct Vent Gas Fireplace P36-LP4 - Manual (Page 55)

FPI P36-4 Zero Clearance Direct Vent Gas Fireplace 55
REGENCY ® OPTIONS
FULL SCREEN DOORS INSTALLATION
2) Full Screen Door Frame Installation
a) Before attaching the Full Screen Door Frame to the unit, loosen the
3 x #8 Philips Head Screws located on the inside top of the outer
frame of the appliance. And remove the center screw.
Also loosen the #8 Philips Head Screw on the inner side of each
hinge bracket as shown below.
1) Before beginning the installation, remove the Screen Doors from the
Full Screen Door Frame by fully opening the doors and lifting up off
of the hinges. See important note in step 7.
Inside Top
of Outer
Frame
Hinge
Bracket
Inner Hinge
Bracket Screw
b) Slide the cut-outs in the Top and Bottom Flange of the Full Screen
Door Frame under the screw heads which were loosened in step 2a.
Once the Frame is in place, tighten screws to secure.
Cut-Outs
Bottom
Flange
Backside of Full
Screen Door
Frame Shown
Cut-Outs
Top
Flange
Inner
Cut-Outs
Bottom
Flange
NOTE: Should the fi nished wall protrude beyond the face of the unit,
you can accommodate up to 1/2" depth.
Simply push in the Full Screen Door Frame until it aligns against
the fi nished wall. Secure Top Flange of Full Screen Door Frame as
described in step 2.
For the Bottom Flange of the Full Screen Door Frame, push the
bottom of the Frame until it aligns with the wall. Use the inner cut-outs
to secure the base of the Frame using the 2 x Hex Head Drill Point
Screws provided.
Backside of Full Screen
Door Frame Shown