Regency Zero Clearance Direct Vent Gas Fireplace P36-LP4 - Manual (Page 18)

FPI P36-4 Zero Clearance Direct Vent Gas Fireplace 18
EXTERIOR VENT TERMINATION LOCATIONS
INSTALLATION
A=
Clearance above grade, veranda, porch, deck, or balcony *(min. 12"/30cm)
B=
Clearance to window or door that may be opened *(12"/30cm)
C=
Clearance to permanently closed window *(min. 12"/30cm)
D=
V
ertical clearance to ventilated sof
fi t located above the terminal within a horizontal
distance of (24"/60cm) from the centerline of the terminal (min. 18"/46cm) check with local code.
E=
Clearance to unventilated sof
fi t (min. 15"/38cm)
F=
Clearance to outside corner: with
AstroCap
T
ermination Cap (min. 6"/15cm), with
Dura-V
ent
Termination Cap (14"/36cm)
G=
Clearance to inside corner: with
AstroCap
T
ermination Cap (min. 6"/15cm), with Dura-
V
ent
Termination Cap (12"/30cm)
H=
Not to be installed above a meter/regulator assembly within (3'/90cm) horizontally from the centerline of the regulator
.
J=
Clearance to service regulator vent outlet *(min. 36"/90cm)
K=
Clearance to non-mechanical air supply inlet to building or the combustion air inlet to any other appliance *(12"/30cm)
L=
Clearance to a mechanical air supply inlet *(min. 72"/1.8m)
M=
Clearance above paved sidewalk or a paved driveway located on public property *(min. 84"/2.1m)
N=
Clearance under veranda, porch, deck, or balcony *(min. 12"/30cm)
Note: - A
vent shall not terminate directly above a sidewalk or paved driveway which is located between two single family dwellings a
nd serves both dwellings.
- Only permitted if veranda, porch, deck, or balcony is fully open on a minimum of two sides beneath the
fl oor
.
- If the vent termination is accessible, a certi
fi ed guard shall be installed.
* As
speci
fi ed in CGA
B149 Installation Code. Note: Local codes or regulations may require dif
ferent clearances.