beautypg.com

Adjusting the volume balance, Optimizing your surround sound, Using the remote control – RocketFish RF-RBREC User Manual

Page 17: 17 rf-rbrec

background image

17

RF-RBREC

4

Adjust the volume level on your audio source or use the remote control.

See the “To set up your remote control:” on

page 17.

Adjusting the volume balance

The volume control on the receiver is only used to adjust the volume
balance between the front and surround speakers. After the system is
set up, we recommend that you adjust the volume balance one time.

Note: After the receiver volume is set, always adjust the volume using the remote
control or volume buttons on your amplifier or external audio device.

Optimizing your surround sound

Wireless links create a small latency between the sender and receiver,
and many A/V receivers let you adjust the delay between the various
speakers in your surround system.
To optimize your system, we suggest that you subtract about 15 ms
from the delay to the surround speakers, this will perfectly match
your surround system.

Using the remote control

• To avoid possible failure, read the following instructions and handle the

remote control properly.

• Do not drop or jar the remote control.

• Do not spill water or any liquid on the remote control.

• Do not place the remote control on a wet object.

• Do not place the remote control under direct sunlight or near sources of

excessive heat.

Caution

: Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type of battery.

Note

: Remove the battery from the remote control when it is not to be used for a long

period. Otherwise it might be damaged due to battery leakage.

To set up your remote control:

1

Remove the insulation sheet before using the remote control for the first

time.

RF-RBREC_09-0475_MAN_ENG_V1.fm Page 17 Friday, August 28, 2009 6:20 AM