RocketFish RF-RBREC - Manual (Page 10)

10
Setting up your wireless receiver
Setting up your remote control
The remote control comes from the factory with an insulating plastic
tab which must be removed to enable the battery. Pull the tab out to
enable the battery on the remote control.
Replacing the remote control battery
To replace the battery:
1 Squeeze and pull to release the battery tray (1). You can remove the
battery tray (2) with your fingernails by using the spaces set back in the
remote control.
4
Next Source button Press to select the audio source. Each press toggles through all the
available sources on your network.
5
INPUT A Press to select between the audio source connecting SPEAKER Input A
or Pre-in A (only applies when you are using the sender in the
RF-RBKIT).
6
INPUT B Press to select between the audio source connecting SPEAKER Input B
or Pre-in B (only applies when you are using the sender in the
RF-RBKIT).
7
Volume buttons (stream) Press to adjust the volume of all devices receiving the same audio
stream or tuned to a station.
8
(mute - all) Press to mute all devices. Press a second time to unmute the stream
that was being listened too. This will unmute all nodes receiving that
stream, but if there are other transmitters sending streams then they
must be unmuted by pointing the remote at a device muted for that
particular stream.
# Feature
/
1
RF-RBREC_09-0475_MAN_ENG_V1.fm Page 10 Friday, August 28, 2009 6:20 AM