Rosewill RNX-G400 - Manual (Page 11)

Wireless Router RNX-G40 User Manual
2 Installation
2.1 Hardware Installation
Step 1: Place the WLAN AP Router to the optimum transmission location. The best transmission location for
your WLAN AP Router is usually at the geographic center of your wireless network, with line of sign
to all of your mobile stations.
Step 2: Prior to connecting the hardware, make sure to power off your Ethernet device, Cable/ADSL modem
and Broadband Router. Then follow the steps below to connect the related devices.
◎Connect your computer to the LAN port.
Attach one end of the Ethernet cable with RJ-45 connector to your hub, switch or a computer’s
Ethernet port, and the other end to one of the LAN ports of your Broadband Router.
◎Connect then Cable/ADSL Modem to the WAN port.
Connect the Ethernet cable attaching to your Cable/ADSL modem to the WAN port of your
Broadband Router.
Step 3 : Connect the power adapter.
Connect the single DC output connector of the power adapter to the power jack on the side of the
Broadband Router. Then plug the Power Adapter into an AC outlet.
Step 4: Power on the following devices in this order:
Cable/ADSL modem, Router, and PCs
The hardware installation is finished.
2.2 Software Installation
¾ There are no software drivers, patches or utilities installation needed, but only the configuration setting.
Please refer to chapter 3 for software configuration.
Notice:
It will take about 1 minute to complete the boot up sequence after powered on the WLAN AP Router;
Power LED will be active, and after that the WLAN Activity LED will be flashing to show the WLAN
interface is enabled and working now.
- 10 -