Radio Shack 43-3817 - Manual (Page 13)

Installation
13
5
'66+0)
"#
761
"6
#.-
Your phone is preset so you must press TALK/
FLASH to answer a call. With Auto Talk turned on,
you can answer a call by just lifting the handset
from the base.
1. Lift the handset and hold down CID/MENU until
the setup menu appears.
2. Press SEL to change the Auto Talk setting.
Ed Ed Ed Ed
or
E\\ E\\ E\\ E\\
appears.
3. To clear the screen when you finish, press END
or return the handset to the base.
6
740+0)
"%
#..'4
"+&1%
#..
"
9
#+6+0)
"1
0
11
((
If you have Call Waiting and Caller ID service, you
can set the system to show Caller ID information for
an incoming call even while you are on the phone.
1. Lift the handset and hold down CID/MENU until
the menu appears.
2. Press 2 or 9 9 9 9 to select
9?:9Mý 9?:9Mý 9?:9Mý 9?:9Mý
(Caller ID/Call
Waiting).
3. Press SEL to change the Caller ID/Call Waiting
setting.
Ed Ed Ed Ed
or
E\\ E\\ E\\ E\\
appears.
4. Press END and return the handset to the base
to store the new setting.
5 614+0) "; 174 "# 4'# "% 1&'
You can store your local area code in the phone’s
Caller ID record so the area code does not appear if
the received call is from your local area. If for some
reason you need to dial the area code (or store it in
memory), you can add it afterwards. See “Adding/
Deleting the Area Code” on Page 24.
±ý
±
"016'"
±
"
If your calling area requires
10-digit dialing (including
area code), do not enter the
area code.