Rhino Mounts SE4 - Manual (Page 18)

SAFETY
SE4 05/05 Safety Section 1-12
© 2005 Alamo Group Inc.
SAFETY
Transporting Safety Instructions and Practices
Be particularly careful when transporting the Implement with the Tractor. Turn curves or go up hills
only at a low speed and using a gradual steering angle. Rear mounted implements move the
center of gravity to the rear and remove weight from the front wheels. Make certain, by adding
front ballast, that at least 20% of the tractor’s weight is on the front wheels to prevent rearing up,
loss of steering control or Tractor tip-over. Slow down on rough or uneven surfaces to prevent
loss of steering control which could result in property damage or possible injury. Do not transport
unless 3-Point lift lever is fully raised and in the latched transport position. Dropping implement in
transport can cause serious damage to the tractor and/or Implement and possibly cause the
operator or others to be injured or killed.
(S3PT-2)
Allow sufficient clearance for the Implement to swing outward while turning. Implements carried
behind the Tractor will swing outside the tire path when making turns. Contacting a solid object
while turning will cause equipment damage and possible injury.
(S3PT-20)
Make certain that the “Slow Moving Vehicle” (SMV) sign is installed in such a
way as to be clearly visible and legible. When transporting the Equipment use
the Tractor flashing warning lights and follow all local traffic regulations.
(SG-6)