Rhino Mounts SE4 - Manual (Page 124)

MAINTENANCE
SE4 05/05 Maintenance Section 5-6
© 2005 Alamo Group Inc.
MAINTENANCE
BLADE REMOVAL
To remove blades for sharpening or replacement. Remove lock nut from blade bolt. NOTE: Inspect lock nut
after removal and replace if threads are damaged. Always replace nut when replacing blade bolt. When
installing blades be sure and check blade bolt pivot diameter for wear. Replace bolt if worn more than 1/4 inch
at any point. Tighten lock nut to 350 ft. lbs.
Avoid personal injury. Blade and/or blade carrier removal should be done only with the tractor
engine shut off, key removed, in neutral, parking brake on, and PTO disengaged and the cutter
blocked in the raised position.
BLADE CARRIER REMOVAL
Remove cotter pin and loosen slotted nut on gearbox shaft. Loosen but do not remove the nut until the blade
carrier is loosened. Use a suitable 2 jaw gear puller to pull carrier off tapered gearbox shaft. If gear puller is
not available use long bar inserted through blade bolt access hole with end against rotor bar. Strike opposite
end of bar with sledge hammer. Rotate blade carrier 180 degrees and repeat process.
BLADE CARRIER INSTALLATION
Clean the splines on both the blade carrier and output shaft. Position carrier on the gearbox output shaft and
install special washer nut.
Tighten nut holding blade carrier to minimum 350 ft. pounds, strike the carrier near the hub several times with a
heavy hammer to seat the hub. Use a suitable spacer over the nut to prevent damage to the nut and threads.
Retighten the nut to 350 ft. pounds. Install cotter pin and spread
IMPORTANT: Always recheck gearbox output shaft slotted blade carrier retaining nut torque after a few hours
operation.
Avoid personal injury. Do not work under cutter without support blocks to keep frame from falling.