Rhino Mounts SE4 - Manual (Page 120)

MAINTENANCE
SE4 05/05 Maintenance Section 5-2
© 2005 Alamo Group Inc.
MAINTENANCE
Before operating your Rotary Cutter, make sure it is properly lubricated and thoroughly inspected. Only a
minimum of time and effort is required to regularly lubricate and maintain this machine to provide long life and
trouble free operation.
Always disengage the PTO before raising the Rotary Cutter for transporting or making
adjustments.
Lubrication
Do not let excess grease collect on or around parts,
particularly when operating in sandy areas. The
illustrations show lubrication points. The chart
gives the frequency of lubrication in hours, based
on normal operating conditions. Severe or unusual
conditions may require more frequent lubrication.
Use an SAE multi-purpose, lithium-type grease for
all locations shown. Be sure to clean the fitting
thoroughly before using grease gun. Failure to
maintain proper lubrication will result in damage to
U-joints, gearbox, and/or driveshaft.
Lubrication Fitting Location
ITEM DESCRIPTION FREQUENCY
1 Driveline U-Joints 8 hours
Driveline Telescoping8 hours
2 Gearbox Check Daily
3 Wheel Hubs Weekly
4 Shield Bearings 16 hours
5 Tailwheel Beam 8 hours