Renesas FLASH Development Toolkit 3.07 - Manual (Page 119)

105
10.2 Dialog Controls
10.2.1 Exit
Clicking this will exit FDT and FDT will start up in the Simple Interface Mode next time it is loaded. This
will be disabled if the user currently logged in to FDT does not have the ‘SimpleInterface:Exit’ access. [see
Chapter 5 for details]
10.2.2 Download File radio button
This will be disabled if the user currently logged in to FDT does not have the ‘SimpleInterface:Download
File’ access. [see Chapter 5 for details]
10.2.3 Download File Area
For devices with a User Boot Area, the user can choose whether to download the file to the User Area or
the User Boot Area.
For devices with a Data Area, the user can choose whether to download the file to the User Area or the
Data Area.
10.2.4 Program Flash \ Erase
Clicking on Program Flash allows FDT to download the specified file or image to the FLASH memory.
Additionally, if Readback Verify is switched off, the Checksum will also be calculated and output to the
screen. If in Batch Erase mode this button will switch to ‘Erase’ and will perform an entire device erase.
10.2.5 Disconnect
Clicking on Disconnect forces FDT to disconnect.
10.2.6 File Selection
The filename can be specified in the File Selection section (by typing or browsing), for each area enabled
by the Download File Area checkboxes