Radio Shack 15-2107 - Manual (Page 6)

6
A Quick Look at the Keys
ˆ
A Quick Look at the
Keys
This section contains a listing of all the remote’s keys for
all available devices that can be setup using this remote
control.
For your device, not every function may be available or
have the same name. For operation details on remote
control keys, refer to the devices’ owner’s manuals.
THE HARD KEYS
The most-often used remote control functions are as-
signed to hard keys and are located below the touch
screen. A beep sounds each time you press a hard key.
If desired, the beep can be disabled (see “Adjusting
Sound” on Page 23).
If a pressed key issues an IR signal, the red light blinks
and
—
flashes.
Note: If the Macro ( 1M , 2M , and 3M ) keys have not been
programmed, the red light and
—
do not flash.
After you select a device, aim the remote control at the
device and use the hard keys as follows:
Key Function
POWER Use to turn the selected device on or
off.
VOL+/ – Use to adjust the volume level of the
selected device.
MUTE Use to mute or restore the volume of
the selected device.
CH+/– Use to change to the next higher (or
lower) channel of the selected device.