Adjusting sound setting up the remote, Adjusting sound, Setting up the remote – Radio Shack 15-2107 User Manual

Page 23

Preparation

8. To save the settings, hold down

SELECT

until

IK9#

9;II

appears.

;N?J?D=

appears, then the last-used

screen.

ADJUSTING SOUND

Your remote has three alert beep tones.

Sound is preset to On. Follow these steps to turn sound
off or on.

1. Hold down

for at least 3 seconds.

9E:;ý I;J

appears.

Note: To exit setup, hold down

for at least 3 sec-

onds.

;N?J?D=

appears, then the last-used mode

screen.

2. Touch the up arrow.

IEKD:

appears.

Note: If you scroll past

IEKD:

, touch the down arrow

to return to it.

3. Touch

SELECT

EEEE<<

appears.

Note: If you change your mind, touch the up or
down arrows until you see

, then continue with

Step 4.

4. Touch

SELECT

IK99;II

appears, then

;N?J?D=

, then

the last-used mode screen.

SETTING UP THE REMOTE

Note: If no key is pressed for 60 seconds, the remote
control automatically exits setup.

;N?J?D=

appears, and

the remote returns to the previous mode screen.

1. Find the codes for your device(s) in “Manufacturers’

Codes” on Page 47. On the supplied label, write

Tone

Type of Alert

One low tone

Valid key press or touch

One high tone

Invalid key press or touch

Double low tone

Valid mode key touch