Using learning, Learning a function – Radio Shack 15-2107 User Manual

Page 40

Operation

3. Touch

SELECT

7BBýCE:;

appears.

To unlock all modes

, touch

SELECT

KDBE9A;:

appears, then

;N?J?D=

, then the last-used mode

screen.

To unlock individual modes

, touch the up or down

arrow.

ED;ýCE:;

appears. Press

SELECT

I;BýCE:;

appears. Touch a mode (for example,

) where

you want the volume controls to be unlocked.

KDBE9A;:

appears, then

I;BýCE:;

Note: If the mode is already unlocked, an error
beep sounds and

?DL7B?:

appears.

To unlock another mode

, repeat Step 4 as often as

needed.

5. To exit the program, hold down

until

;N?J?D=

appears. The last-used mode screen appears.

USING LEARNING

Your remote control is equipped with a learning program
so you can add a function unique to a home entertain-
ment device (for example, tracking up or down for a
VCR). You can skip this section if you are satisfied with
the remote control operation on all devices.

Learning a Function

This method assumes all devices have been set up. If
not, perform the instructions in “Setting Up The Remote”
on Page 23. Also, have your original remote controls
handy before programming learning.

Follow these steps to learn a function.

1. Select the mode key for the desired learning mode.

2. Hold down

for at least 3 seconds.

9E:;ý I;J

appears.

Note: To exit setup, hold down

for at least 3 sec-

onds.

;N?J?D=

appears, then the last-used mode

screen.