Roland ME-25 - Manual (Page 12)

12
Appendices
You can restore the settings in the ME-25 (memories, tuner
reference pitch, and knob response method) to the values set when
the unit was shipped from the factory.
Performing a factory reset causes all settings saved in memory to be
lost. If you want to keep the memory settings, use the ME-25 Librarian
(p. 11) to save them on a computer.
1. Hold down [EXIT] and press the MEMORY
pedal.
“FA” appears in the display.
2. Press [WRITE].
The Tuning Guide flashes.
3. Press [WRITE] again.
The display flashes and the factory reset is executed.
Never turn off the power while factory reset is in progress.
The ME-25’s expression pedal has been set for optimal operation at
the factory. However, extended use and certain operating
environments can result in the pedal going out of adjustment.
If you encounter problems such as the expression pedal’s ON/OFF
switch not functioning or the volume pedal not fully cutting off the
sound, you can use the following procedure to readjust the pedal.
When operating the expression pedal, be careful not to get your
fingers pinched between the movable part and the panel. In places
with small children, an adult should provide supervision and
guidance until the child is capable of following all the rules essential
for the safe operation of the unit.
1. Hold down [EXIT] and press the SOLO Pedal.
The display shows “Pd” then “Up.”
2. Move the heel of the expression pedal all the
way down, then release the pedal and press
[WRITE].
The display shows “dn.”
3. Move the toe of the expression pedal all the way
down, then release the pedal and press [WRITE].
A value indicating the current stiffness (sensitivity) of the
expression pedal switch appears in the display.
If the display flashes in Steps 2 or 3, press the pedal again, and then
press [WRITE].
4. Use the MEMORY / pedals to adjust the
stiffness (sensitivity) of the expression pedal
toe switch.
The lower the value, the more easily the switch will respond,
even when pressed lightly.
This is set to “5” when shipped from the factory.
5. Press [WRITE].
The setting is saved in memory.
Restoring the Factory Settings
(Factory Reset) Adjusting the Expression
Pedal
* Essentially, effects are connected in the order illustrated above. However, this order may change automatically in order to optimize the connection order
and accommodate particular settings.
Signal Flow
EFFECT
INPUT
OUTPUT
PHONES
COMP/FX OD/DS PREAMP PEDAL FX
VOLUME
(PEDAL)
MODULATION
NOISE
SUPPRESSOR
DELAY REVERB
USB
IN
USB
OUT
AUX IN
USB
ME-25_e.book 12 ページ ２００９年１２月１８日 金曜日 午後１０時３８分