Roland PC-300 - Manual (Page 22)

Program Number has been specified.
Note also that the Bank Select values are
memorized until the next sound has
been successfully selected. So, if even one
out of the complete set of three values is
mistakenly not supplied, part of the pre-
vious values could be sent along with the
newly specified ones. As a result, you
might not obtain the sound you need.
A: Does your computer music application
use Program Numbers 0~127 for sound
selection? Since the PC-300 uses num-
bers 1~128, you may need to add one to
the number being selected to obtain the
correct sound.
Q: The GS module does not respond to
Aftertouch messages.
A: By default, a GS sound module does not
respond to Aftertouch messages.
Therefore, you need to set the Aftertouch
parameters using Exclusive messages.
(Refer to the MIDI Implementation for
the sound module in question.) If using
a computer-based system, you may be
able to easily make the required settings
using the software.
20
PC-300
11. Specifications
Keyboard
49 keys (velocity sensitive)
MIDI control
MIDI Channels (1~16)
Octave Shift (Up/Down, Standard, all note
numbers between 00 and 127)
Bender/Modulation lever
Data Entry slider: Controller Numbers
00/32 (GS Variation selection), Channel
Aftertouch, Velocity, Reverb Send Level,
Chorus Send Level, Volume, Panpot, CC
Select (control change numbers
CC00~127)
Rear panel
Power Switch, Sustain Switch jack, AC IN
jack, MIDI OUT connector, USB connec-
tor, KEYBOARD/PC switch
Power supply
DC 9 V: AC adapter, USB
Current draw
80 mA
Dimensions
816 (W) x 175 (D) x 80 (H) mm
32-1/8 x 6-15/16 x 3-3/16 inches
Weight
2.5 kg / 5 lbs 9 oz
Accessories
Owner’s Manual, MIDI cable, USB cable,
adapter
Options
DP-2/DP-6 Footswitch
Note: In the interest of product development,
the specifications and/or appearance of this
unit are subject to change without prior
notice.