Roland FC-200 - Manual (Page 11)

11
PROGRAM CHANGE MODE
This is the mode for sending Program Change messages and Control Change messages.
About Program Change Numbers
The Program Change numbers (1 to 128) are obtained by adding the Program Change number
corresponding to the Bank (0 to 12) to the Program Change number corresponding to the Number
(1 to 10).
Banks 0 to 12 correspond to Program Change numbers as shown below.
Bank 0 1 2 ... 11 12
Program Change number 0 10 20 ... 110 120
Numbers 1 to 10 correspond to Program Change numbers as shown below.
Number 1 2 3 ... 9 10
Program Change number 1 2 3 ... 9 10
For Bank 1 and Number 6, for instance, the Program Change number is 10 + 6, or 16.
For Bank 2 and Number 10, the Program Change number is 30 (20 + 10).