Runco VX-2i - Manual (Page 36)

Operation
26 Runco VX-2i Owner’s Operating Manual
4.3
Lens Adjustments To access the motorized lens controls, select Display Device from the Service Menu, then
select Lens from the Display Device menu. The Lens menu gives you a great deal of
control over the picture size, position and focus:
Focus To focus the projected image, use the cursor buttons to highlight “In” or “Out.” Then,
press and hold the ENTER button.
Zoom To make the picture smaller (zoom out), use the cursor buttons to highlight the minus sign
(-). Then, press and hold the ENTER button.
To enlarge the picture (zoom in), use the cursor buttons to highlight the plus sign (+).
Then, press and hold the ENTER button.
Shift To change the projected image position, use the cursor buttons to highlight “Left,”
“Right,” “Up” or “Down.” Then, press and hold the ENTER button to shift the image in that
direction.
4.4
Using the On-Screen
Menus Press the MENU button on either the remote control or the rear panel to display the Main
Menu, shown below. To select a menu item, use the UP and DOWN buttons on either the
remote control or the rear panel to highlight it. Press ENTER to confirm your selection.
The VX-2i OSD menus are arranged hierarchically, as shown in Figure 4-1.
➤
➤
➤