Adjusting the projection angle, Mounting, Floor mounting – Runco VX-2i User Manual
Page 29: Ceiling mounting, Folded optics, Figure 3-6 . folded optics, 6. folded optics
Runco VX-2i Owner’s Operating Manual
19
Adjusting the Projection
Angle
If the screen is significantly higher or lower than the projector, you can also tilt the
projector at a slight angle. In a ceiling installation, you do this by adjusting the ceiling
mount.
If you do this, you may need to shift the image using the on-screen display (OSD) controls,
to compensate. For detailed instructions, refer to
Mounting
There are several methods for mounting the projector. Depending on your chosen
installation, one method may be more suitable than another.
Floor Mounting: In typical front and rear screen installations, the projector can be
mounted to a secure and level surface such as a table or cart. Carts are useful when
moving a projector during a presentation or from site to site. If possible, lock the wheels
when it’s in position to prevent it from being moved during a presentation.
Ceiling Mounting: The projector can also be inverted and suspended from the ceiling
using a specially designed ceiling mount fixture. This type of mounting is recommended
for fixed installations and for those that want the projector out of sight or have a limited
space for projector and audience.
Folded Optics
In rear screen applications where space behind the projector is limited, a mirror may be
used to fold the optical path, as shown in Figure 3-6. The position of the projector and
mirror must be accurately set. If you are considering this type of installation, contact your
dealer for assistance.
Figure 3-6. Folded Optics
Use only the Runco-approved ceiling mount kit designed for your
projector.
Note