Radio Shack 43-3578 - Manual (Page 36)

36
Ca
ller ID
Oper
ation
A
DDING
/D
ELETING THE
A
REA
C
ODE
The display shows the area code of an
incoming call, unless the call comes
from the area code you stored (see
“Storing Your Area Code” on Page 17).
You can add the area code to the
display or delete it. With the record
displayed, press 3 to add or delete the
area code.
Numbers are stored in memory as they
appear on the display, with or without
the area code. Numbers in Caller ID
records remain the same, even if you
add or delete the area code.
D
IALING
N
UMBERS FROM
A
C
ALLER
ID R
ECORD
To dial a local number stored in a Caller
ID record, recall the record, then press
TALK/FLASH .
To add or delete the area code, press 3
before you press TALK/FLASH .
If the call is long distance, press 1
( 1 appears before the displayed
number) before you press TALK/FLASH .
Ф
Ф
NOTE
Ô
If a Caller ID record
does not contain a
phone number (if it was
blocked by the caller, for
example), you cannot
dial from that record.
43-3578.book Page 36 Thursday, February 12, 2004 3:12 PM