Radio Shack 43-3578 - Manual (Page 24)

24
Operation
I
NSTALLING THE
B
ELTCLIP
To attach the beltclip
Insert the beltclip into the holes on each
side of the handset. Press down until it
clicks.
To remove the beltclip
Pull both sides of the beltclip to release
the tabs from the holes.
U
SING A
H
EADSET
You can make or answer calls with
hands-free convenience using an
optional headset that has a 3 /
32
-inch
(2.5-mm) plug. Your local RadioShack
store has a variety of headsets available.
To connect the headset, gently flip
open the rubber headset jack cover on
the side of the handset, then insert the
headset’s plug into the jack. Ô
Connecting a headset disconnects the
handset’s earpiece and microphone.
VOL / or VOL / on the handset also
controls the headset’s volume.
With a headset connected, you can
make or answer calls as usual using
the keys on the handset.
When you finish using the headset,
disconnect it from the handset and close
the rubber cover to protect the jack.
Ô
NOTES
Ô
• If you place the
handset on the base
to recharge it while
the headset is
connected, be sure
the handset seats
properly.
• You can use a
handset holder
(available from your
local RadioShack
store) to hang the
handset on your belt
for greater
convenience when
using a headset.
43-3578.book Page 24 Thursday, February 12, 2004 3:12 PM