Radio Shack 43-3578 - Manual (Page 12)

12
Installation
For direct wall
mounting, align
the bracket’s
keyhole slots
with the
mounting screws
and slide the base downward to
secure it. Then, plug the modular
cord's other end into a telephone
outlet.
6. Plug the adapter into a standard
AC outlet.
7. Lift the base’s antenna to a vertical
position.
C
ONNECTING
/C
HARGING
THE
B
ATTERY
P
ACK
The battery pack and the battery
compartment cover are packed
separately. Before using your phone,
you must connect the battery pack,
then charge it for about 15–20 hours. !
1. Plug the battery pack’s connector
into the socket in the compartment
(the connector fits only one way),
then place the battery pack in the
compartment.
2. Apply the battery cover to the
handset and slide upward. Then,
using a screw driver (not supplied),
tighten the screw at the bottom of
the cover.
!
IMPORTANT
!
The EPA
certified
RBRC
®
Battery
Recycling
Seal on
the nickel-cadmium (Ni-
Cd) battery indicates
RadioShack is volun-
tarily participating in an
industry program to
collect and recycle these
batteries at the end of
their useful life, when
taken out of service in
the United States or
Canada. The RBRC
program provides a
convenient alternative to
placing used Ni-Cd
batteries into the trash or
the municipal waste
stream, which may be
illegal in your area.
Please call 1-800-THE-
SHACK (1-800-843-
7422) for information on
Ni-Cd battery recycling
and disposal bans/
restrictions in your area.
RadioShack’s
involvement in this
program is part of the
company’s commitment
to preserving our
environment and
conserving our natural
resources.
43-3578.book Page 12 Thursday, February 12, 2004 3:12 PM