Radio Shack 43-3578 - Manual (Page 18)

18
Installation
3. Press SEL , then enter your three-
digit area code. If you make a
mistake, use the
DEL/CH to erase
the wrong number, then enter the
correct number.
4. Press SEL to store the area code,
then return the handset to the base
(or press
END ) to clear the display. !
S
ETTING THE
D
IALING
M
ODE
Your phone is set for tone dialing. If you
have pulse service, change the dialing
mode. If you are not sure which type of
service you have, do this test.
1. Lift the handset, press TALK/
FLASH , and listen for a dial tone.
2. Press any number other than 0 . Ô
If the dial tone stops, you have
touch-tone service. If the dial tone
continues, you have pulse service.
3. Press END .
Follow these steps to set the dialing
mode.
1. Lift the handset then hold down
CID/MENU until the menu appears
with Auto Talk selected.
!
IMPORTANT
!
In some areas, the area
code is necessary even
for a local call. If you live
in such an area, do not
store the area code.
Ô
NOTE
Ô
If your phone system
requires that you dial an
access code (9, for
example) before you
dial an outside number,
do not dial the access
code.
43-3578.book Page 18 Thursday, February 12, 2004 3:12 PM