Using the sp-303 with a turntable, Adding effects to the turntable sound – Roland SP-303 User Manual
Page 63
62
Chapter 8. Examples of Using the SP-303
The performance from the MIDI keyboard is
simultaneously recorded to the MIDI sequencer.
* For more on the correspondence between notes and samples,
3. Stop recording on the MIDI sequencer.
Just as before, when the MIDI sequencer is played back,
the MIDI sound module’s rhythm part or the SP-303’s
sample plays.
* To return the SP-303 to its regular operating status, hold
down [EXT SOURCE] while switching ON the POWER
switch.
Using the SP-303 With a Turntable
Adding Effects to the Turntable Sound
This describes the procedure for adding effects with the SP-303 to the sound from turntables, DJ mixers, and such devices.
Connections
fig.r08-09
1. Raise the send level of the DJ mixer.
2. Play a record on the turntable.
3. Press the SP-303’s [EXT SOURCE], causing the button
to light up.
Here, it is convenient to have [GATE] off, as the sound is
not cut off even when [EXT SOURCE] is released.
4. Press one of the SP-303’s effect buttons, and confirm
that the button has lit.
5. Gradually raise the DJ mixer Return level and the SP-
303’s volume level.
The effect becomes audible.
6. Turn the CTRL 1–3 knobs to adjust the effect sound.
* If no effect sound is needed, turn the DJ mixer’s Return level
down completely.
PHONO A
PHONO B
SEND
RETURN
Power Amplifier
DJ Mixer
Turntable
Turntable
SP-303