Roland SP-303 - Manual (Page 17)

17
QUICK START
Quick Start
If you don’t like the sampled sound
Delete the sound that you sampled, and start again from step
3. The procedure is as follows.
fig.Q11
a. Press [DEL] and confirm that the button has lit.
The pad to which the sample is assigned blinks.
“dEL” appears in the display.
b. Press the pad to which the unwanted sample is
assigned.
The pad light stays on, and [DEL] blinks.
c. Press [DEL].
[DEL] changes from blinking to steadily lit, and the dots
in the display blink.
The deletion is complete when the dots remain off.
* The deletion process may take anywhere from several seconds
up to around a minute to complete; please wait until the
process is completed.
Never turn off the power while the dots are blinking.
Turning off the power at this point may result in
corruption of data not only in the sample that was being
deleted, but in other samples as well.
If undesired sound or silence was recorded at the
beginning or end of the sample, you can make settings so
that only the desired portion is played back.
For more detailed information, refer to “Preventing
Unneeded Portions from Being Played (Markers/Start
Point/End Point)” (p. 38).
a,c
b