Roland SP-303 - Manual (Page 38)

37
Chapter 4. Changing the Sampling Settings
Chapter
4
fig.r04-04
1. Confirm that [PATTERN SELECT] is not lit.
If [PATTERN SELECT] is lit, press it so that the button’s
light goes out.
2. Press the pad to which the sample whose Gate or
Trigger setting you want to make is assigned.
The pad will light, and the sample will sound. This pad
becomes the current pad.
3. Press [GATE], and confirm that the button has turned
on or off.
[GATE] lit: Gate Playback
[GATE] not lit: Trigger Playback
* If [LOOP] is not lit, then when the sample is played back to
the end, then playback stops automatically, even if the pad is
held down, and the pad light goes out.
Playing Samples in the Reverse
Direction (Reverse Playback)
Reverse Playback plays samples backwards from the end of
the sample, providing an effect like that of a tape being
rewound.
fig.r04-05
* Time Modify (p. 42) and Reverse Playback cannot be selected
at the same time. Time Modify settings are disregarded during
Reverse Playback.
fig.r04-06
1. Confirm that [PATTERN SELECT] is not lit.
If [PATTERN SELECT] is lit, press it so that the button’s
light goes out.
2. Press the pad which contains the sample that you wish
to playback in reverse.
The pad will light, and the sample will sound. This pad
becomes the current pad.
3. Press [REVERSE], and confirm that the button has lit.
[REVERSE] lit: Reverse Playback
* Pressing [REVERSE] toggles between Reverse Playback and
normal playback ([REVERSE] is not lit).
* When Reverse Playback is selected, the Start and End Points
(p. 38) are reversed.
1
3
2
Normal
Reverse playback
1
3
2