Roland SP-303 - Manual (Page 23)

23
Chapter 2. Using the Effects
Chapter
2
Applying Effects to All
Samples Simultaneously
If you want an effect to be applied to all of the pads at once, it
would be time consuming if you needed to press all the pads.
Thankfully, though, a simple procedure you can use when
applying an effect to all of the pads has been provided.
* This operation applies the effect to all pads in Banks A–D.
fig.r02-05
1. While holding down [REMAIN] (CURRENT PAD),
press the button for the effect to be used.
The pressed effect button blinks.
All of the pads light up (the current pad blinks), and the
effect is applied to all of the pads.
* A pad to which no sample is assigned doesn’t light up.
* To revert to having the effect applied only to the current pad,
hold down [REMAIN] (CURRENT PAD) again and press the
blinking effect button.
* You cannot apply/remove effects for individual pads while the
effect button is blinking.
Effect Button Effect
Lit The effect is applied to one or more
samples.
Blinking The effect is applied to all 32
samples (4 banks x 8 pads).
1