Ricoh CL3000DN - Manual (Page 70)

Troubleshooting
66
5
It takes too much time to com-
plete the print job. Photographs and other data intensive pages take a long time
for the printer to process, so simply wait when printing such
data.
Changing the settings with printer driver may help to speed
up printing.
See the printer driver's Help.
The data is so large or complex that it takes time to process
it. If the Data In indicator is blinking, the data is being proc-
essed. Just wait until it resumes.
If "Warming Up..." appears on the panel display, the printer
is now warming up. Wait for a while.
It takes too much time to resume
printing. The data is so large or complex that it takes time to process
it. If the Data In indicator is blinking, the data is being proc-
essed. Just wait until it resumes.
The printer was in the Energy Saver mode. To resume from
the Energy Saver mode, the printer has to warm up, and this
takes time until printing starts. To disable the Energy Saver
mode, select "Off" for "Energy Saver" in the System Settings
menu.
Multiple pages are fed at once. Number of paper set in the tray exceeds the limit. Confirm
that the top of the stack is not higher than the limit mark in-
side the tray.
See p.15 “Paper and Other Media”.
Paper is static. Use paper that has been stored properly.
When loading paper, separate paper from each other.
See p.15 “Paper and Other Media”.
Paper is either too thick or too thin.
See p.15 “Paper and Other Media”.
Paper is not fed from the select-
ed tray. When using the Bypass Tray, confirm that the paper size and
the feed direction on the tray are the same as the ones set
with the control panel.
See p.24 “Loading Paper in the Bypass Tray”.
When you are using a Windows operating system, the print-
er driver settings override those set using the control panel.
Set the desired input tray using the printer driver.
See the printer driver's Help.
Status Possible Causes, Descriptions, and Solutions
AresPGBMaintGuide-F_FM.book Page 66 Friday, July 26, 2002 5:17 PM