Ricoh CL3000DN - Manual (Page 16)

Getting Started
12
1
Network Standard Model Exterior: Rear View
1. Ventilator
The ventilator helps to keep the compo-
nents inside the printer from overheat-
ing. Do not block the ventilator as it may
cause a printer malfunction due to over-
heating.
2. Right Cover
Open this cover when replacing photo
conductor units, the transfer belt or waste
toner bottle.
3. Power Switch
Use this switch to turn the power on and
off.
4. Standard Tray Extension
Pull out this extension when printing on
paper of its length is longer than that of
A4 or 8
1 /
2
” × 11”.
5. Controller Board
Slide this out when installing options
such as Memory Unit, Printer Hard Disk,
1394 Interface Unit, 802.11b Interface
Unit, USB2.0 Interface Unit or User Ac-
count Enhance Unit.
6. Parallel Port
Use a parallel cable to connect the printer
to the computer.
7. USB Port
Use a USB cable to connect the printer to
the host computer.
8. Ethernet Port
Use a network interface cable to connect
the printer to the network.
9. Ventilator
The ventilator helps to keep the compo-
nents inside the printer from overheat-
ing. Do not block the ventilator as it may
cause a printer malfunction due to over-
heating
10. Optional Paper Feed Unit Con-
nector
Use the Paper Feed Unit connector to
connect the printer to the Paper Feed
Unit.
11. Power Port
Connect the power cable to this port and
the other end of the cable to the outlet.
ZHBH030E
1
2
3
6
8
9
10
11
5
7
4
ZHBH700E
AresPGBMaintGuide-F_FM.book Page 12 Friday, July 26, 2002 5:17 PM