Radio Shack 43-3820 - Manual (Page 20)

T
e
lephone O
per
at
ion
20
'PVGTKPI"C"2CWUG
Some telephone systems require you to dial an
access code (9, for example) and wait for a second
dial tone before you can dial an outside number.
You can store the access code with the phone
number. However, you should also store a pause
after the access code to allow the outside line time
to connect.
To enter a 2-second pause, press RDL/PAUSE .
FFFF
appears. You can add more pause entries for a
longer pause.
4GXKGYKPI"/GOQT["0WODGTU
To review your memory numbers, press MEM . The
list of memory location numbers (
''''
–
&&&&
) appears with
the name stored with each number (or
2C[cehoýd4 2C[cehoýd4 2C[cehoýd4 2C[cehoýd4
if you did not store a name).
To see the stored phone numbers, press #/
7 7 7 7
. An
arrow to the right of the number means it is longer
than 14 digits. Press
#### 7
again to see the rest of the
number. Repeatedly press
∗∗∗∗
6 6 6 6
/TONE to return to
the name display.
To exit the memory number list, press END .
To see a stored name and phone number at the
same time, press
CH/SEL when the cursor is by a
memory location number. To exit this display, hold
down
TRSF/DEL until the screen clears, or press
END .
&KCNKPI"C"/GOQT["0WODGT
1. Lift the handset and press MEM to dial a stored
memory number. The list of memory location
numbers appears.
2. Choose a memory location ( 0 – 9 ) by pressing a
number or by repeatedly pressing
8 8 8 8
or
9
,
then press TALK/FLASH .