Radio Shack 43-3820 - Manual (Page 14)

T
e
lephone O
pera
tion
14
1. Lift the handset and hold down CID/MENU until
the menu appears.
2. Press 3 or
9 9 9 9
twice to select
ý7h[Wý9eZ[ ý7h[Wý9eZ[ ý7h[Wý9eZ[ ý7h[Wý9eZ[
.
3. Press CH/SEL , then enter your three-digit area
code. If you make a mistake, repeatedly press
∗∗∗∗
6 6 6 6
/TONE or
####
7
to move the cursor over the
incorrect digit, then enter the correct number.
±ý
4. Press CH/SEL to store the area code, then
press END or return the handset to the base or
cradle to clear the display.
6'.'2*10'"12'4#6+10
/
#-+0)
"
#0&
"4
'%'+8+0)
"%
#..5
1. To make a call, lift the handset and press TALK/
FLASH .
9edd[Yj_d] 9edd[Yj_d] 9edd[Yj_d] 9edd[Yj_d]
, then
JWba JWba JWba JWba
and the current
volume setting (see “Setting the Handset
Volume” on Page 15) appear on the handset.
If you set the ringer to off,
2H_d][hýE<<4 2H_d][hýE<<4 2H_d][hýE<<4 2H_d][hýE<<4
appears
under the volume setting. The base’s CHARGE
LED lights.
2. Dial the number. The number appears on the
handset as you dial, then the call’s elapsed
time appears.
You can also dial the number before you press
TALK/FLASH . If you make a mistake, repeatedly
press TRSF/DEL to erase the wrong entry, then
enter the correct number. Hold down TRSF/DEL to
delete the entire number.
When you receive a call,
?dYec_d]ý9Wbbý ?dYec_d]ý9Wbbý ?dYec_d]ý9Wbbý ?dYec_d]ý9Wbbý
appears. Lift
the handset from the base or cradle and press
TALK/FLASH . If auto talk is on, just lift the handset
from the base or cradle. If the handset is away from
the base or cradle, press
TALK/FLASH or any
±
"016'"
±
"
If an area code is already
stored, it appears on the
display. To delete the area
code, press TRSF/DEL
three times, then enter your
area code. Or you can use
∗∗∗∗
6 6 6 6
/TONE or
#### 7
to move
the cursor and edit the area
code