Radio Shack 43-3820 - Manual (Page 12)

In
s
ta
lla
ti
o
n
12
If the battery power is too low, the dial mode might
reset to tone. If you are on a pulse line and cannot
make a call, try re-setting the dialing mode to pulse.
5
'66+0)
"
6*'
"*
#0&5'6
N
5
"4
+0)'4
"
6
10'
18
1.7/'
You can select one of the handsets’ four different
ringer tone/volume settings or turn the ringers off.
You can also select a different tone/volume for each
handset.
At any time, except during a call, repeatedly press
8 8 8 8
or
9
to select the desired ringer setting. Each
time you press a button, the phone rings at the
selected setting and
H_d]ýJof[ý7 H_d]ýJof[ý7 H_d]ýJof[ý7 H_d]ýJof[ý7 >_]^ >_]^ >_]^ >_]^
,
H_d]ýJof[э7э H_d]ýJof[э7э H_d]ýJof[э7э H_d]ýJof[э7э
Bem Bem Bem Bem
,
H_d]ýJof[э8э>_]^ H_d]ýJof[э8э>_]^ H_d]ýJof[э8э>_]^ H_d]ýJof[э8э>_]^
,
H_d]ýJof[ý8ýBem H_d]ýJof[ý8ýBem H_d]ýJof[ý8ýBem H_d]ýJof[ý8ýBem
,
ээээ
or
H_d][hэE\\э H_d][hэE\\э H_d][hэE\\э H_d][hэE\\э
appears.
6
740+0)
"
6*'
"$
#5'
N
5
"4
+0)'4
"
1
0
11
((
"
You can set the base’s ringer to high or low, or turn
it off.
1. Press SET/RING . The phone’s currently set ring
sounds, and the current setting appears. When
the ringer is set to
E< E< E< E<
, the phone announces
“Off.”
±
2. Repeatedly press SET/RING to change the
current setting. The system rings at each
setting change and
>_ >_ >_ >_
,
Be Be Be Be
, or
E\ E\ E\ E\
appears.
3. Press PLAY/STOP to store and exit the setting
mode.
Even when you turn off the base’s ringer, you can
still make or receive calls using this phone.
Telephones on the same line and the handset (if its
ringer is not turned off) still ring when there is an
incoming call.
±
"016'"
±
"
The phone exits the setting
mode if you:
• wait more than 2
seconds between key
presses
• receive an incoming call
• press PLAY/STOP
• press TALK/FLASH on
the handset
Start again at Step 1.