Ricoh Aficio 8060 - Manual (Page 91)

Messages Displayed When Using the Scanner Function
83
5
Cannot detect the
paper size of the
original. Specify
the scanning
size.
The set original was mis-
aligned. • Place the original correctly.
• Specify the scan size.
• When placing an original directly
on the exposure glass, the lift-
ing/lowering action of the ADF
triggers the automatic original size
detection process. Lift the ADF by
more than 30 degrees.
Cannot add any
more scanning
mode.
The maximum number of
registerable scan modes
has been exceeded. The maximum number of modes that
can be stored is 100. Delete unneeded
modes.
Cannot specify
any more scanning
area.
The maximum number of
registerable scan areas
has been exceeded. The maximum number of scanning are-
as that can be stored is 100. Delete un-
needed scanning area.
Call Service
Please call your
service repre-
sentative.
An unrecoverable error
has occurred in the ma-
chine. Call your service representative.
Scanner is not
available on the
specified device.
The TWAIN scanner
function cannot be used
on this machine. Contact your service representative.
Scanner is not
available. Check
the scanner con-
nection status.
• The machine's main
power switch is off.
• The machine is not
connected to the net-
work correctly.
• Set the main power switch to “On”.
• Check whether the machine is con-
nected to the network correctly.
• Deselect the personal firewall func-
tion of the client computer.
• Use an application such as telnet to
make sure SNMPv1 or SNMPv2 is
set as the machine’s protocol. See
“Network Settings”, General Set-
tings Guide and “Using telnet”,
Network Guide.
No response from
the scanner.
The machine is not con-
nected to the network
correctly. Check whether the machine is connect-
ed to the network correctly.
No response from
the scanner.
The network is crowded. Wait for a while, and then try to recon-
nect.
Error has oc-
curred in the
scanner.
The application-speci-
fied scan conditions have
exceeded the setting
range of the machine. Check whether the scanning settings
made with the application exceed the
setting range of the machine.
Fatal error has
occurred in the
scanner.
An unrecoverable error
has occurred on the ma-
chine. An unrecoverable error has occurred in
the machine. Call your service repre-
sentative.
Message Cause Solution