Ricoh Aficio 8060 - Manual (Page 45)

Messages Displayed When Using the Facsimile Function
37
3
The specified
group contains
some destina-
tion(s) that do
not have access
privileges. Do
you want to se-
lect only the
privileged desti-
nation(s)?
The specified group con-
tains some destinations
for sending by e-mail and
some destinations for
sending by Scan to Fold-
er. To select destinations for sending by e-
mail, press [Select] for the message dis-
played on the e-mail screen. To select
destination for sending by Scan to Fold-
er, press [Select] for the message dis-
played on the Scan to Folder screen.
Cannot find the
specified path.
Please check the
settings.
The name of the compu-
ter or folder entered as
the destination is wrong. Check whether the computer name and
the folder name for the destination are
correct.
Sender has not
been specified.
The sender has not been
specified. A sender's name should be specified
before sending e-mail. Send e-mail after
specifying the sender's name.
E-mail address
entered is not
correct. Please
re-enter.
The entered e-mail ad-
dress is wrong. Make sure the e-mail address is correct,
and then enter it again.
You do not have
the privileges to
use this func-
tion.
Use of this function is re-
stricted. Contact the administrator.
Authentication
has failed.
Wrong login user name
or password. Confirm correct login user name or
password.
Authentication
has failed.
Authentication is not
possible from this ma-
chine. Contact the administrator.
Check whether
there are any
network problems.
{ 13-10 }
The alias telephone
number you entered is al-
ready registered on the
gatekeeper by another
device. • In [Facsimile Features], under [Initial
Settings] , select [H.323 Settings], and
then check the alias telephone
number is correctly programmed.
You can also use the Web Image
Monitor for confirmation. See the
Web Image Monitor's Help.
• Consult the administrator.
Check whether
there are any
network problems.
{ 13-11 }
Cannot access gatekeep-
er. • In [Facsimile Features], under [Initial
Settings] , select [H.323 Settings], and
then check “Gatekeeper Address” is
correctly programmed. You can also
use the Web Image Monitor for con-
firmation. See the Web Image Mon-
itor's Help.
• Consult the administrator.
Message Cause Solution