Radio Shack 43-3821 - Manual (Page 12)

In
s
ta
lla
ti
o
n
12
If your phone system requires that you dial an
access code (9, for example) before you dial an
outside number, do not dial the access code.
The phone exits setting mode if a call or page is
received, or if you press
END .
If the battery power is too low, the dialing mode
might reset to tone. If you are on a pulse line and
cannot make a call, try resetting the dialing mode to
pulse.
5 '66+0) " 6*' "* #0&5'6 N 5 "4 +0)'4 "
6 10'
You can select either a high or low ringer tone
setting while the phone is not in use.
Lift the handset and press VOL/RING to hear the
current ringer setting. Repeatedly press VOL/RING
to select the desired ringer setting.
6
740+0)
"
6*'
"$
#5'
N
5
"4
+0)'4
"1
0
1
1
((
"
You can set the base’s ringer to high or low, or turn
it off.
1. Press SET/RING . The phone’s currently set ring
sounds, and the current setting appears.
2. Repeatedly press SET/RING to change to the
desired setting. The system rings at the setting
and
>_ >_ >_ >_
,
Be Be Be Be
, or
E\ E\ E\ E\
appears. When the ringer is set
to
E\ E\ E\ E\
, the phone announces “Off.” ±ý
Even when you turn off the base’s ringer, you can
still make or receive calls using this phone.
Telephones on the same line and the handset (if its
ringer is not turned off) still ring when there is an
incoming call.
±
"016'"
±
"
The phone exits the setting
mode if you:
- wait more than 2 seconds
between key presses
- receive an incoming call
- press PLAY/STOP
- press TALK on the
handset
If the phone exits the
setting mode, start again at
Step 1.
43-3821.fm Page 12 Friday, May 10, 2002 10:08 AM