Ricoh INFOPRINT XT GLD0-0025-01 - Manual (Page 86)

There might be occasions when you want to embed some or all the permanent
resources inline with the AFP data stream for the job. InfoPrint XT provides the
xinlr conversion parameter, which you can use to specify which permanent
resources you want InfoPrint XT to embed. You can specify one or more types of
printable resources, such as AFP page segments and AFP character sets. You can
also specify that InfoPrint XT embeds all types of printable resources. For the
syntax of the xinlr conversion parameter, see page 96.
Processing limitations
In the Xerox environment, the printer can only process one job at a time. Because
InfoPrint XT can convert jobs simultaneously, a limitation exists that applies to
concurrently processing jobs that use FILE DJDEs. If you have several jobs that
specify the same resource group or location, do not submit them at the same time.
Unpredictable results can occur.
Do not submit a job that uses FILE DJDEs to load two different resources with the
same name. For example, if the first report in the job loads one version of the
image abc.img and the second report loads another version of abc.img ,
unpredictable results can occur.
Including resource-load messages for FILE DJDE jobs
The default is that InfoPrint XT does not include messages about the resources that
it loads from FILE DJDE commands. You can instruct InfoPrint XT to include
resource-load messages in the x2afp.lst file for the job by setting an environment
variable. See:
v “Controlling resource-load messages for FILE DJDE jobs
(PDXT_AIOLXDFE_TRACE)” on page 24
v “x2afp.lst file” on page 90
Processing jobs that contain stapling commands
You can process jobs that contain Xerox stapling commands with InfoPrint XT.
Xerox OUTPUT STAPLE PDL commands, combined with FACEUP and NTO1
commands, specify stapling actions. InfoPrint XT supports these combinations of
the three commands:
OUTPUT STAPLE=YES and OUTPUT FACEUP=YES and OUTPUT NTO1=YES
OUTPUT STAPLE=YES and OUTPUT FACEUP=YES and OUTPUT NTO1=n
InfoPrint XT provides these conversion parameters that you can specify with the
job to control stapling: xhonorstaple , xstaplemax , xstapleorient , and
xstaplesysgen . For more information about these parameters, see Appendix A,
“Conversion parameters for converting Xerox jobs,” on page 93.
Notes:
1. Some restrictions apply when InfoPrint XT processes jobs that contain stapling
commands. See page 7.
2. Always review the documentation for your particular printer for the latest
information about features and capabilities. For example, stapling capacities
and supported media differ between printer models. See these publications:
v InfoPrint 2190, 2210, & 2235 Printers (MT 2707): Planning Guide, G550-0952
v InfoPrint 2060ES/2075ES/2090ES/2105ES: Finishing Guide for Printing, S544-5845
v InfoPrint 70 Plus: Introduction and Planning Guide, GA18-7726
v InfoPrint 70: Introduction and Planning Guide, G544-5869
66 InfoPrint XT Guide
|