Ricoh INFOPRINT XT GLD0-0025-01 - Manual (Page 30)

v ¹ InfoPrint XT ignores these commands when it finds them in a job. InfoPrint XT
processes the job and issues informational messages that state that it ignored the
commands.
v ² This is a CME parameter.
v ³ InfoPrint XT only supports this command when you use it with the STAPLE
command.
v ⁴ Restrictions apply to this command. See page 6.
v ⁵ If you compile an FSL to an FRM that contains LOGO references in its internal
font list or logo list, InfoPrint XT supports those references. However, InfoPrint
XT does not support a LOGO DJDE in the data stream.
v InfoPrint Solutions Company can negotiate support for non-supported DJDEs on
the basis of customer need.
10 InfoPrint XT Guide
|
|