RadioLAN Campus BridgeLINK - Manual (Page 123)

890-007 Rev. A 01/28/99 Page 113 © 1999 RadioLAN, Inc.
Appendix A: Indicators, Switches, and Connectors
Indicators
10BaseT Port LEDs
There are two built-in LEDs located on the 10BaseT connector which provide link and port activity information.
•
The CAR LED (green) is active when the port is connected to another powered 10BaseT port whose signaling
meets the requirements for an IEEE 802.3i 10BaseT device (for example, valid link test pulses are detected
on the receive pair).
•
The ACT LED (green) is active when receive activity is detected or during a packet transmission.
Power LED
The Power LED (green) is active when power is provided to the unit.
Fault LED
The fault LED (amber) is active when a fault is detected during power up diagnostics.