Renesas SuperH SH7600 Series User Manual
Page 33
27
Figure 2.4 [Performance Analysis] Dialog Box
Measurement range
One of the following ranges can be specified. This depends on the item selected for [Mode]
in the [Performance Analysis] dialog box.
1. From the start to the end of the user program execution (When Normal Break is
selected for [Mode])
2.
From the satisfaction of the condition set in Break Condition 1 to the satisfaction of the
condition set in Break Condition 2 (When Break condition 1->2 is selected for
[Mode])
3.
From the satisfaction of the condition set in Break Condition 2 to the satisfaction of the
condition set in Break Condition 1 (When Break condition 2->1 is selected for
[Mode])
(In the second and third ranges, [PA-1 start point] and [PA-1 end point] are displayed on the
[Action] part in the [Break condition] sheet of the [Event] window.)
For measurement errors,
•
The measured value includes errors.
•
Error will occur before or after a break.
Notes: 1. When the second and third ranges are specified, execute the user program after the
measurement start condition is set to Break Condition 1 (or Break Condition 2) and the
measurement end condition to Break Condition 2 (or Break Condition 1).