Renesas SuperH SH7600 Series - Manual (Page 24)

18
Table 2.5 lists the combinations of conditions that can be set under Break Condition 1, 2, 3.
Table 2.5 Dialog Boxes for Setting Break Conditions
Type
Dialog Box Address Bus
Condition
(Address) Data Bus
Condition
(Data) Bus State
Condition
(Bus Status) Count
Condition
(Count)
Internal
I/O Break
[Break Condition 1]
dialog box O O O O X
[Break Condition 2]
dialog box O X O X X
[Break Condition 3]
dialog box X X X X O
Note: O: Can be set in the dialog box.
X: Cannot be set in the dialog box.
2.2.3 Trace Functions
The SH7630 E10A emulator supports the trace functions listed in table 2.6.
Table 2.6 Trace Functions
Function Internal Trace AUD Trace
Branch trace Supported (eight branches) Supported
Range memory access trace Not supported Supported
Software trace Not supported Supported
Table 2.7 shows the type numbers that the AUD function can be used.
Table 2.7 Type Number and AUD Function
Type Number AUD Function
HS7630KCM01H, HS7630KCI01H Not supported
HS7630KCM02H, HS7630KCI02H Supported