Radio Shack ET-1118 - Manual (Page 16)

16
• The redial memory for each keypad
is separate. You cannot redial a
number you dialed on the handset’s
keypad using
REDIAL on the base’s
keypad, and vice versa.
• The redial memory holds up to 32
digits, so you can redial long-dis-
tance as well as local numbers.
• The redial memory also holds pause
entries. See “Entering a Pause” on
Page 20.
USING FLASH
FLASH performs the electronic equiva-
lent of a switchhook operation for spe-
cial services, such as Call Waiting.
For example, if you have Call Waiting,
press
FLASH to answer an incoming call
without disconnecting the current call.
Press
FLASH again to return to the first
call.
Note: If you do not have any special
phone services, pressing
FLASH might
disconnect the current call.
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-
by-phone, require tone signals. If you
have pulse service, you can still use
these special tone services by following
these steps.
1. Be sure DIAL MODE is set to P .
2. Dial the service’s main number.
3. When the service answers, press
TONE ( ) on the handset ( TONE on
the base). Any additional numbers
you dial are sent as tone signals.
4. When you hang up, the phone auto-
matically resets to pulse dialing.
USING PAGE/INTERCOM
You can use the ET-1118 as a two-way
pager and intercom between the base
and the handset. This is useful if the
handset is away from the base and you
want to locate it, or if you want to have a
conversation between someone with the
handset and someone at the base.
REDIAL
FLASH
INTCOM