Radio Shack ET-1118 - Manual (Page 14)

14
TELEPHONE OPERATION
MAKING AND RECEIVING
CALLS WITH THE
HANDSET
To make a call, lift the handset, then
press
TALK . The IN USE indicator on
the base lights. Dial the number. You
see the number as you dial, then (about
5 seconds later) the call’s elapsed time.
Note: You can also dial the number be-
fore you press
TALK . If you make a mis-
take, repeatedly press DELETE until the
incorrect digit is deleted, then enter the
correct number. To delete the entire
number, hold down
DELETE for over one
second.
To answer a call, lift the handset from
the base and press
TALK . If auto talk is
on, just lift the handset from the base,
or, if the handset is away from the base,
press any key to answer a call.
To end a call, place the handset on the
base or press
TALK .
ADJUSTING THE
HANDSET VOLUME
To adjust the volume of the sound you
hear through the handset, during a call,
press or . The display shows
Vol-
ume Low , Volume Medium , Volume
High , or Volume Maximum . When
you press when the volume is maxi-
mum or when the volume is low, the
error tone sounds.
MAKING AND RECEIVING
CALLS WITH THE
SPEAKERPHONE
To make or answer a call using the
speakerphone, press
SPEAKER . The
SPEAKER indicator lights. When you
hear a dial tone, dial the number.
To set the speakerphone’s volume, slide
VOLUME on the right side of the base.
To end a speakerphone call, press
SPEAKER again.
SWITCHING BETWEEN
THE HANDSET AND
SPEAKER
To switch to the speakerphone while
you are using the handset, press
SPEAKER on the base. When you hear
the conversation or dial tone on the
speakerphone, press
TALK on the hand-
set.
SPEAKER
VOLUME